Can Am Outlander 500 Maintenance Schedule

Question

Answer

Can Am X3 service intervals?

The Can-Am Maverick X3 has no break-in maintenance required and only an annual maintenance schedule, which means reduced total maintenance costs. The yearly advised maintenance is at 1,865 miles (3,000 km) or 200 hours.

How do you reset the maintenance code on a Can Am Commander?

Registered. You can leave the key on as long as you want but as soon as you hit the override button the rest has to be done within 5 seconds. Turn the key off and wait until the guages completely shut down ( about 10 seconds) then should be good to go. Worked for me.

Can Am Maverick oil change intervals?

Maverick Maintenance Can-Am recommends changing the oil every 100 hours or 2,000 miles, whichever one comes first.

Can Am Maverick X3 Turbo R break in period?

The manual says to break in after 10 hours or 200 miles. My first weekend riding was a success, as I exceeded 10 hours.

How do you reset the maintenance light on a 2020 Defender?

1) With vehicle in park, turn ignition key on but do not start the engine. 2) Select the vehicle total mileage using the Mode button. 3) Press the Set button and hold while you switch the Hi and Low beam 3 times quickly.

What is override switch on Can Am Commander?

Override button overrides it and gives you more power.

Can Am Commander stuck in limp mode?

Easiest is to disconnect it on the frame side directly under steering adjustment. And you can also just turn the key off until the ecm shuts all the way down (dash lights go off). This typically resets a “soft” limp home until it gets the code again.

Can Am Outlander check codes?

The first step is to reset the odometer by pressing the Trip and Reset buttons while the ignition key is turned on. When the key is turned ON, release the odometer Reset and Trip buttons to see if the Diagnostic Trouble Code or DTC appears on the odometer display.

Can Am x3 misfire code?

Code P0303 Causes Cylinder 3 misfires can be caused by many reasons from a faulty ignition system, fuel system, or internal engine failure. The most common reason for this to happen is faulty or worn-out spark plug coil packs, especially if it’s been a while since you had a tune-up. What is this?

What kind of oil does a Can Am Outlander take?

What Type Of Oil Does Can-am Outlander Take? Three quarts of XPS 5W-40 synthetic blend oil, an oil filter, an o-ring and washers, and a disposable funnel are included in this oil change kit.